Programming The Electronic Head; Step 1: Setting The Date & Time; Step 2: Performing Manual Regeneration - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener

Programming the Electronic Head

Note: Power Source - For safety reasons the outlet must be protected by a Ground Fault Circuit
Interrupter (GFCI).
Note: Do not make changes to the settings unless instructed by a Technical Support representative.
Your system is pre-set to regenerate every 3 days at 2:00 am, the complete process takes 20 minutes
Step 1: Setting the Date & Time
1. Press and hold the MENU button until you hear the beep to unlock.
2. Press MENU button for menu.
3. Press SET once Date & Time Setting is highlighted.
4. Using the UP and DOWN buttons input the correct Date and Time pressing SET after each input.
5. Once set press the MENU button to return to the main menu.
IMPORTANT!
You will need to manually regenerate (Regen Now) your system prior to use. To do so follow the
programming below. You will not be able to use water for 20 minutes during this process.
Notice:
In the event of spikes in Iron and Manganese levels you may choose to manually regenerate your
system if you experience colored water from your system.
Step 2: Performing a Manual Regeneration
1. Using the DOWN button select Manual Regen and press SET.
2. Using the UP or DOWN button select either Regen Now or Regen Tonight.
-Regen Now will start a regeneration process immediately.
-Regen Tonight will regenerate the system at the default regeneration time of 2:00am.
3. Once selected press the SET button to confirm. Gears will make noise and water will start to
flow. Allow the system to regenerate for approximately 20 minutes.
4. Once complete press the MENU button to return to the main menu.
5. The programming is now complete
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
MENU
SET
Rev T
Page 22
www.pelicanwater.com
(877) 842-1635