Carbon Soak - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
Water Filter - Carbon Soak
!IMPORTANT!
Your system will not be ready for use for a minimum of 48 hours while the Carbon Soak process takes
place. Please plan your installation accordingly.
Notice:
Water will flow out of the outlet side of the Bypass Valve during this process. Be sure you perform this
series of steps in a location suitable for water flow.
Figure 3
1. Attach a garden hose to the Hose Bib Assembly.
2. Connect the Hose Bib Assembly to the inlet side of the Bypass Valve and hand tighten.
3. Fill the Whole House Water Filter until water comes out of outlet side of the Bypass Valve.
4. Turn the water off.
5. Remove the garden hose from the Hose Bib Assembly. Do not remove the fitting.
6. Allow the carbon to soak for a minimum of 48 hours prior to installation.
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Garden
Hose
Hose Bib
Assembly
Bypass Valve
Water
INLET
Whole House Water Filter
Rev T
Page 10
www.pelicanwater.com
(877) 842-1635