Natursoft - Media Soak; Natursoft - Media Flush - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener

NaturSoft - Media Soak

Wall
Incoming
Water
Supply
Sediment Filter
Solution Tank
Figure 12
CAUTION:
The Whole House Water Filter MUST be in the bypass position during this process (see Figure above).
1. Open a cold water faucet or spigot downstream of the Water Softener.
2. Slowly turn the water back on at the main shut-off valve allowing the system to fill with water.
The air being displaced will escape through the open fixture downstream.
3. Turn the arrows on the Bypass Valve into the Bypass Mode position to bypass the tank. This will
allow you to isolate the tank and restore water supply to the home/building during the NaturSoft
media soak.
4. Allow the tank to soak for at least 60 minutes.

NaturSoft - Media Flush

CAUTION:
The Pelican Whole House Water Filter MUST be in the bypass position during this process (see Figure).
1. After the tank has soaked for 60 minutes, turn the main water supply back on or turn the arrows
on the Bypass Valve back into their original position.
2. Flush the system by running water for 5 minutes at a high flow rate of 5 GPM (this can be
achieved by using a bath tub or more than 3 faucets).
Note: The flush water may have a milky look to it. This is normal as calcium carbonate fines are
flushed from the system.
3. Rinse the system by reducing the flow rate to ½ GPM and run water for 60 minutes (this can be
achieved by turning one faucet ¼ of the way on).
4. Turn the Whole House Water Filter Bypass Valve back into service position. (out of Bypass).
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Chemical Injector
Electronic
Head
Whole House
Iron & Manganese Filter
Pump
Drain Line
Barb
Whole House
Water Filter
Rev T
Page 20
Wall
Spigot
Outgoing
Water to
House
Salt Free Water
Softener/Conditioner
www.pelicanwater.com
(877) 842-1635