Carbon Flush - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener
Water Filter - Carbon Flush
!IMPORTANT!
Do not perform the Carbon Flush until the Carbon Soak process is complete.
Notice:
Water will flow out of the outlet side of the Bypass Valve during this process. Be sure you perform this
series of steps in a location suitable for water flow.

Carbon Flush

Figure 4-1
1. Reattach the garden hose to the Hose Bib Assembly.
2. Slowly turn on the water less than a 1/4 turn on the hose spigot.
3. Run water through the inlet side of the Bypass Valve for 30 minutes to expel the carbon fines.
4. Turn off the water.
5. Remove the Hose Bib Assembly from the inlet side and attach it to the outlet side of the Bypass Valve.
6. Slowly, fully open the hose spigot.
7. Run the water through the outlet side for 3 minutes to reset the carbon.
8. Turn off the water.
9. Remove the Hose Bib Assembly from the Bypass Valve and disconnect the garden hose.
Note: Please save the Hose Bib Assembly as this will be used in the future for the carbon replacement.
Carbon Reset
Figure 4-2
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Water
Garden
Hose
Hose Bib
Assembly
Hose Bib
Assembly
Garden
Hose
Water
Bypass Valve
INLET
Whole House Water Filter
Bypass Valve
INLET
Whole House Water Filter
Rev T
Page 11
www.pelicanwater.com
(877) 842-1635