Iron And Manganese Tank Installation - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener

Iron and Manganese Tank Installation

Wall
Incoming
Water
Supply
Sediment Filter
Solution Tank
Figure 9
1. Level the Whole House Iron & Manganese Filter.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line from the In-Line Injection Port
and choose the appropriate fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
Part Description
1" PVC Tail Adaptor for
Electronic Head Bypass
3. Remove the gray cap from the top of the Whole House Iron & Manganese tank.
4. Screw the Electronic Head onto the tank hand-tight.
5. Install the fittings onto the inlet and outlet, following the arrows on the Bypass Valve and head.
6. Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.
7. Connect the outgoing water supply to the outlet side of the Bypass Valve.
8. Firmly press one end of the discharge Tubing Drain Line onto the barbed nose, and secure the
other end of the line to a drain.
© 2019 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Chemical Injector
Pump
Electronic
Head
Whole House
Iron & Manganese Filter
Qty.
2
Drain Line
Barb
Whole House
Water Filter Softener/Conditioner
Bypass Valve
Tail Adaptors
Rev T
Page 15
Wall
Spigot
Outgoing
Water to
House
Salt Free Water
Electronic Head
Red Clips
www.pelicanwater.com
(877) 842-1635