Iron And Manganese Tank Installation - Pelican WF6 Owner's Manual

Pelican WF6/WF10 Iron/Manganese Filter and Salt Free Softener

Iron and Manganese Tank Installation

Wall
Incoming
Water
Supply
Chemical
Pre-Filter
Injector
Pump Tubing
Solution Tank
Figure 8
Notice:
Follow the raised black arrows on the head of the Whole House Iron & Manganese tank.
1. Level the Pelican Whole House Iron & Manganese Filter.
Notice:
If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands
vertical. The bottom of the tank is round and the boot allows the tank to stand upright.
2. Determine the size and material of your incoming water supply line from the In-Line Injection Port
and choose the appropriate fittings required to connect it to the Bypass Valve.
CAUTION:
Do not over-tighten any of the fittings during installation.
Table 2: Bypass Valve Fittings
Part Description
1" PVC Tail Adaptor for
Electronic Head Bypass
Note: The fitting above is designed with a ¼" give to allow for proper pipe alignment. It will not leak and
is intended to have some flexibility.
3. Remove the gray cap from the top of the Whole House Iron & Manganese tank.
4. Screw the Electronic Head onto the tank hand-tight.
5. Install the fittings onto the inlet and outlet, following the arrows on the Bypass Valve and head.
© 2013 Enviro Water Solutions, Inc.
3060 Performance Circle, Suite 2, DeLand, FL 32724
Chemical Injector
Pump
Electronic
Head
Whole House
Iron & Manganese Filter
Qty.
2
Discharge
Line
Whole House
Water Filter
Rev P
Page 13
Wall
Spigot
(optional)
Outgoing
Water to
House
Salt Free Water
Softener/Conditioner
www.pelicanwater.com
(877) 842-1635