Analog Output (Retransmission); Figure 3.9 Flow Chart For Analog Output Menu - Omega i Series User Manual

3.2.10 Analog Output (Retransmission)

This unit is equipped with three physical outputs that can only be configured as
follows:
a) Alarm 1, Alarm 2 & Analog Out
b) Output 1, Alarm 2 & Analog Out
Analog Output is available only if the Analog Output option board is factory
installed.
is required that you put the controller in the Standby Mode for any
It
configuration change other than Set Points & Alarms.
Figure 3.9 Flow Chart for Analog Output (Retransmission)
ENTER ANALOG OUTPUT MENU:
Press a
Press d
Press a
Press d
CURRENT/VOLTAGE SUBMENU:
Press d
Press b
Press d
1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Press a , if necessary, until Display advances to ANLG
Analog Output Menu.
4) Display advances to Analog Output CURR or VoLT
Current/Voltage Submenu and flashes the previous selection.
5) Display flashes CURR Current or VoLT Voltage.
6) Scroll through the available selection: Current or Voltage.
(Example VoLT ).
7) Display shows STRD stored message momentarily and then
advances to RD1 Submenu only if it was changed, otherwise
press a to advance to RD1 Reading 1 Submenu.
40