Set Points - Omega i Series User Manual

3.2.2 Set Points

SETPOINT 1:
Press a
Press d
Press b & c 3) Press b and c to increase or decrease Setpoint 1
Holding b & c buttons down for approximately 3 seconds will speed up the
rate at which the set point value increments or decrements.
Press b & c 4) Continue to use b and c to enter your 4-digit Setpoint 1 value.
Press d
SETPOINT 2:
Press d
Press b & c 7) Press b and c to increase or decrease Setpoint 2
Holding b & c buttons down for approximately 3 seconds will speed up
the rate at which the setpoint value increments or decrements.
Press d
1) Press a, if necessary until SP1 prompt appears.
2) Display shows previous value of "Setpoint 1" with 1
flashing.
respectively.
5) Display shows STRD stored message momentarily and then
advance to SP2 only, if a change was made, otherwise press a
to advance to SP2 Setpoint 2 Menu.
6) Display shows previous value of "Setpoint 2" with 1
flashing.
respectively.
8) Display shows STRD stored message momentarily and then
advances to CNFG only, if a change was made, otherwise press
a to advance to CNFG Configuration Menu.
18
digit
st
digit
st