Output 1 Menu - Omega i Series User Manual

ENTER OUTPUT 1 MENU:
Press a
Press d
Press a
Press d
SELF SUBMENU:
The Self Option allows the output of the instrument to be controlled manually
from the front panel.
Press d
Press b
Press d
There is a shorter way to Enable or Disable Self Mode. From a Run
Mode, press d and then press a . Self Mode is Enabled now. Press b or
c to display MXX.X. To disable Self, press d and then press a . Display
goes to the Run Mode. Self Mode is Disabled now.
MINIMUM/PERCENT LOW SUBMENU:
Specify in percent, the minimum value (0000) for control output. If the output is
analog proportional (Current or Voltage), then the minimum voltage or current, in
percent, is specified. If the output is time proportional (Relay, SSR or Pulse),
then the minimum duty-cycle, in percent, is specified.
Press d
Press b & c 10) Use b and c buttons to enter a new value for "Percent Low".
Press d
1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Press a , if necessary, until Display advances to OUT1 Output
1 Menu.
4) Display advances to SELF Self Submenu.
5) Display flashes the current setting of Self, ENBL Enabled or
DSBL Disabled.
6) Press the b button to select between Enable and Disable.
7) If Self ENBL Enabled was selected, display shows STRD
stored message momentarily and then advances to the next
menu (Output 1 setting is completed).
The output is now under the direct control of the operator and
can be adjusted in the Run Mode ( M00.0 to M99.9 ), by
pressing the b and c buttons, where M calls for the Manual
(Self) Control. For example, setting of M50.0 of an Analog
Output of
0 to 10 Vdc would produce roughly 5 Vdc at the output.
8) If Self DSBL Disabled was selected, display shows STRD
stored message momentarily and then advances to oPLO
Minimum/Percent Low Submenu of Output 1 Menu.
9) Display flashes 1st digit of previous "Percent Low" setting.
11) Display shows STRD stored message momentarily and then
advances to oPHI Maximum/Percent High Submenu.
34