Input Type (Rtd) - Omega i Series User Manual

Input Type (RTD)

ENTER INPUT TYPE MENU:
Press a
Press d
Press d
RTD SUBMENU:
Press b
Press d
Press d
Press b
Press d
RTD Types: 392
Display:
392.2 , 392.3 , 392.4 , 385.2 , 385.3 , 385.4
Last digit indicates: 2-, 3- or 4-wire input.
RTD VALUE SUBMENU:
Press d
Press b
Press d
RTD Values: 100 ohm
Display:
100_
1) Press a, if necessary, until CNFG prompt appears.
2) Display advances to INPT Input Menu.
3) Display flashes T.ç , RTD or PROC (Thermocouple, RTD or
Process). If the displayed input type is RTD , press a to skip to
step 6 ( RTD stops flashing).
4) Scroll through the available selection to RTD (flashing).
5) Display shows STRD stored message momentarily and then
RTD (not flashing).
6) Display flashes previous RTD type selection i.e. 392.2
(see below for RTD types selection).
7) Scroll through the available RTD types to the selection of
your choice.
8) Display shows STRD stored message momentarily and then
advances to RTD RTD value.
9) Display flashes previous RTD value selection i.e. 100_
(see below for RTD value selection).
10) Scroll through the available RTD values to the selection of
your choice.
11) Display shows STRD stored message momentarily and then
advances to RDG Reading Configuration Menu.
500 ohm
500_
385
1000 ohm
1000
21
Two, Three or Four-wire