Toro 03708 Operator's Manual page 22

the machine, with the cutting units in the down position,
press the lift switch down to allow the cutting units to
float and mow.
Throttle Control
Move the control (Figure 27) forward to increase the
engine speed and rearward to decrease the speed.
Light Switch
Press the lower edge of the switch (Figure 27) to turn on
the lights. Press the upper edge of the switch to turn
off the lights.
Glow Plug Indicator Light
When lit, the glow plug indicator light (Figure 27)
indicates that the glow plugs are on.
Engine Coolant Temperature Warning
Light
The light (Figure 27) illuminates and the cutting units
shut down (PTO disengages). If the temperature
continues to rise the engine will shut down.
Power Point
The power point (Figure 28) is used to power optional
12 volt electrical accessories.
1. Power point
2. Engine cooling fan switch
Engine Cooling Fan Switch
The machine is equipped with a hydraulically driven auto
reversing engine cooling fan. The fan switch (Figure 28)
Figure 28
3. Bag holder
4. Hour meter
has two positions R (manual reverse) and Auto (normal).
Refer to Engine Cooling Fan Operation in the Operation
Section of manual.
Bag Holder
Use the bag holder (Figure 28) for storage.
Hour Meter
The hour meter (Figure 28) shows the total hours that
the machine has been operated.
Backlap Levers
Use the backlap levers for backlapping the reels
(Figure 29).
1. Front backlap lever
Reel Speed Control
The reel speed control regulates the speed of the front
and rear cutting units (Figure 30). The reel speed
increases as the knob is turned clockwise.
22
Figure 29
2. Rear backlap lever