Toro 03708 Operator's Manual page 16

1. Hose guide (Left hand
shown)
2. Rod bracket
1
1. Hose guides (each must lean toward the center cutting unit)
Note: When installing or removing the cutting
units, make sure the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
6. On 27 inch cutting units only, increase the steering
on the rear cutting units by removing the (2) pivot
spacers, hex socket screws and flange lock nuts
(Figure 15) from the rear (#2 and #3) cutting unit
carrier frames (Figure 12).
Note: 32 inch cutting units are not equipped with
pivot spacers.
Figure 13
3. Nuts
Figure 14
16
1
g019602