Table of Contents
Advertisement
6
Using the Cutting Unit
Kickstand
Parts needed for this procedure:
1
Cutting unit kickstand
Procedure
Whenever the cutting unit has to be tipped to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure the nuts on the back
end of the bedbar adjusting screws are not resting on the
work surface (Figure 22).
Figure 22
1. Cutting unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure 23).
1. Chain bracket
2. Snapper pin
7
Greasing the Machine
No Parts Required
Procedure
Before the machine is operated, it must be greased to
ensure proper lubrication. Refer to Lubrication section.
Failure to properly grease the machine will result in
premature failure of critical parts.
8
Checking Fluid Levels
No Parts Required
Procedure
1. Check the rear axle lubricant level before the engine
is first started, refer to Checking the Rear Axle
Lubricant in Drive System Maintenance.
19
Figure 23
3. Cutting unit kickstand
Advertisement
Table of Contents
