Setup; Checking The Tire Pressure; Reading The Manual And Viewing; The Safety Video - Toro 07280 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
2
Safety Video
Registration Card
Predelivery Inspection Form
Key
Note: Determine the left and right sides of the
machine from the normal operating position.
Step
1

Checking the Tire Pressure

No Parts Required
Procedure
Check the tire pressure every 8 hours or daily to
ensure proper levels.
The air pressure range in the front and rear tires
is 8-22 psi (55-152 kPa).
The air pressure needed is determined by the
payload carried. Lower air pressure will provide
less compaction, a smoother ride, and fewer tire
marks. Lower pressure should not be used for
heavy payloads at high speeds.
Higher pressures should be used for heavier
payloads at higher speeds. Do not exceed the
maximum pressure.
Description
Step
Reading the Manual and
Viewing the Safety Video
Parts needed for this step:
Procedure
• Read the Operator's Manual and Engine Operator's
• View the safety video.
• Fill out the registration card.
• Complete the Predelivery Inspection Form.
12
Qty.
–
Check the tire pressure.
1
1
1
Read the Operator's Manual and
1 watch the video before operating
the machine.
1
1
2
2
1 Operator's Manual
1
Engine Operator's Manual
1 Parts Catalog
1 Safety Video
1 Registration Card
1 Predelivery Inspection Form
2 Key
Manual.
Use