Toro 07280 Operator's Manual page 14

position to allow operation of the vehicle and
accessories. After stopping the vehicle, rotate the
key counterclockwise to the Off position. Remove
the key before leaving the vehicle.
Figure 5
1. On/Off switch
2. Horn button
3. Light switch
4. Battery/hour meter
Horn Button
Press the horn button to activate the vehicle horn
(Figure 5).
Gear Shift Selector
The battery/hour meter provides you with an
indication of how much charge is contained in the
batteries (Figure 5 and Figure 9) and the number of
operating hours on the vehicle. The battery meter
is located at the top of the LCD screen. When the
vehicle batteries are fully charged, ten bars extend
from the 0 to the 1 position. As the charge is
used, bars disappear starting on the right side. For
detailed information on the battery meter, refer
to Understanding and Using the Battery System
in Operation, page 17.
The hour meter is located at the bottom of the
LCD screen. It logs operating hours whenever
the key is in the On position and the vehicle is in
motion.
Vehicle Direction Switch
Use this switch (Figure 5) to toggle between
forward and reverse operation.
Vehicle Status Light
The vehicle contains a computer that monitors
the state of the vehicle electrical systems. This
5. Vehicle status light
6. Power cargo bed switch
(optional)
7. Rear lift switch (optional)
8. Vehicle direction switch
computer communicates the status of the vehicle
to you through the vehicle status light. Always
check this light when you turn the On/Off switch
to the On position (Figure 9) When there are no
problems and the vehicle is operational, the light
is on.
When there is a problem, the light flashes. The
light flashes at various intervals for different
problems and events. If the light blinks, refer to
Troubleshooting, page 33 for a description of the
flash codes.
Light Switch
Use this switch to turn the headlights on and off
(Figure 5).
Cargo Bed Lift Switch (Optional)
Use this switch to raise and lower the cargo bed
(Figure 5).
Rear Lift Switch (Optional)
Use this switch to raise and lower the rear lift
(Figure 5).
Supervisor Speed Limit Switch
The supervisor speed limit switch, located under
the cup holder (Figure 6) has two positions: Off
and On. Rotate the key clockwise to the On
position to limit the maximum vehicle speed to a
factory setting of 12 mph (19 kph). Rotate the key
counterclockwise to the Off position to restore the
maximum speed of the vehicle.
Figure 6
1. Supervisor speed limit switch
14