Storage - Toro 07280 Operator's Manual

Storage

1. Position the machine on a level surface, set
the parking brake, turn the machine Off, and
remove the key.
2. Clean dirt and grime from the entire machine,
including the outside of the engine's cylinder
head fins and blower housing.
Important: You can wash the machine
with mild detergent and water. Do not use
high pressure water to wash the machine.
Pressure washing may damage the
electrical system or wash away necessary
grease at friction points. Avoid excessive
use of water, especially near the control
panel, lights, engine, and the battery.
3. Inspect the brakes; refer to Inspecting the
Brakes in Brake Maintenance, page 31.
4. Grease the machine; refer to Lubrication,
page 24.
5. Check the tire pressure; refer to Checking the
Tire Pressure.
6. Remove the spark plugs and check their
condition; refer to Changing Spark Plugs in ,
page .
7. Charge the batteries fully before placing the
vehicle into storage, refer to Maintaining the
Batteries in Electrical System Maintenance,
page 25. Plug the charger into a wall outlet
while the vehicle and batteries are in storage.
Leave the charger plugged into a wall outlet
and charging receptacle during storage to
ensure that the batteries stay charged and do
not freeze; otherwise, charge the batteries at
least once every 3 months.
8. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
9. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Dealer.
10. Store the machine in a clean, dry garage or
storage area.
11. Remove the key and put it in a safe place out
of the reach of children.
12. Cover the machine to protect it and keep it
clean.
32