Siemens SINAMICS Series Operating Instructions Manual page 61

Status-screen wizard
The status-screen wizard allows the user to configure the
information displayed on the status screen. By default it
displays output voltage and output frequency of the Inverter.
These can be changed by using the wizard to select other
physical values of the Inverter. Displayed units of value can
be specifically adapted using known conversion factors and
with the addition of an offset value to allow the units of
measure to be displayed as required for the users
application.
Scalar value
The bar graph (default status screen) and the Scalar value are setup using a similar
procedure. The example below show how to setup the Scalar value status screen.
1.
2.
3.
Intelligent Operator Panel (IOP)
Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB
From the Set Status-Screen menu select "Scalar
Value".
Select the screen position of the displayed values
Select the parameter values that should be displayed
on the status screen.
Menu
6.5 Extras
61