Siemens SINAMICS Series Operating Instructions Manual page 34

Intelligent operator panel. intelligent commissioning and application configuration tool

Hide thumbs Also See for SINAMICS Series:

Table of Contents

Wizards

4.1 Example wizard

10. Enter the correct pulses per revolution for the encoder.

11. Select the required macro source.

12. Set the minimum speed at which the attached motor

13. Set the ramp-up time in seconds.

14. Set the ramp-down time in seconds.

The information is normally printed on the casing of the

encoder.

See Basic commissioning with IOP (Page 32).

should run.

This is the time in which the motor will take to reach the

selected motor speed.

This is the time the motor will take from being given the

OFF1 command to reaching a standstill.

Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB

Intelligent Operator Panel (IOP)

Table of Contents