Siemens SINAMICS Series Operating Instructions Manual page 35

15. A summary of all the settings are displayed.
16. The final screens gives two options:
Examples of macro (P0015) IO pre-assigments
The following example shows the pre-assigned inputs and outputs that are setup
automatically depending upon the macro that is selected during basic commissioning.
The input and output assignments are specific for each individual type of Control Unit and
therefore, the information given below is only as an example.
It is important that the user refers to the Operating Instructions for their specific Control Unit
where detailed information is given regarding the pre-assignment of inputs and outputs.
It is possible to manually configure the inputs and outputs if a suitable macro cannot be
found for the users application; detailed information on manually configuring the input and
outputs is also given in the Operating Instructions for each specific Control Unit.
Intelligent Operator Panel (IOP)
Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB
If the settings are correct, select continue.
• Save settings
• Cancel Wizard
If the save option is selected, a factory reset will be
performed, then the settings are saved to the converter
memory. The location of the saved data is assigned
using the "Parameter Saving Mode" function in
"Parameter Settings" in "Menu".
Wizards
4.1 Example wizard
35