Siemens SINAMICS Series Operating Instructions Manual page 18

Installation
3.2 Initial Set-up
Setting time and date
When the IOP is first fitted to a Control Unit, which has a real-time clock, it will automatically
display the time and date screen, the following actions should be performed:
1. The "Time and Date" screen is displayed.
2. Rotate the Wheel to change the value.
3. Press the Wheel to confirm the value and move to the
next field.
4. Rotate the Wheel to change the value.
5. Press the Wheel to confirm value and move to the next
field.
6. Continue the process for the date fields.
7. When the last field of the date is completed, the screen
will return to the "Extras" menu.
8. Press "Esc" for more than 3 seconds to return to the
"Status" screen.
The settings for time are normally done on the Control Unit if it has a Real-time Clock (RTC).
If the Inverter has an RTC the IOP will take its settings from the Control Unit.
Lighting duration
To set the length of time that the display remains lit, the following actions should be
performed:
1. Rotate the Wheel to select "Menu".
2. Press the Wheel to confirm selection.
3. The "Menu" screen is displayed.
4. Rotate the Wheel to select "Extras".
5. Press the Wheel to confirm selection.
6. The "Extras" screen is displayed.
7. Rotate the Wheel to select "Panel Settings"
8. Press the Wheel to confirm selection.
9. Rotate the Wheel to selected "Lighting duration".
10. Press the Wheel to confirm selection.
11. The "Lighting duration" screen is displayed.
12. Rotate the Wheel to select the required lighting duration.
13. Press the Wheel to confirm selection.
14. The display returns to the "Extras" menu.
15. Press "Esc" for more than 3 seconds to return to the
"Status" screen.
18
Operating Instructions, 04/2015, FW V1.5.1, A5E00110011C AB
Intelligent Operator Panel (IOP)