Fisher & Paykel RX216DT7XV2 Installation Instructions And User Manual page 44

Troubleshooting
42
Ice and water
Problem
Ice maker is
not producing
enough ice or ice is
malformed.
Ice forms in inlet
tube to ice maker.
Refrigerator is
leaking water.
Possible causes
Ice maker has just been
installed or a large amount
of ice has been used.
Water pressure is too low.
Water filter is clogged or
needs to be changed.
Water pressure is too low.
Saddle valve not open
completely.
Freezer temperature is too
high.
Plastic tubing was used to
complete water connection.
Improper water valve was
installed.
What to do
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Low water pressure can cause valve to leak.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Change water filter (see page 28).
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Open saddle valve completely.
See temperature controls, page 12 or 17.
Freezer temperature should be between 0° to
2° F (-18° to -17° C).
It is recommended copper tubing is used
for installation. Plastic is less durable and
can cause leakages. The manufac turer is not
responsible for property damage due to
improper installation or faulty/leaky water
connection.
See connecting the water supply,
pages 9 – 10. Self-piercing and 3⁄16" (4.7 mm)
saddle valves cause low water pressure
and may clog the line over time. The
manufacturer is not responsible for property
damage due to improper installation or
water connection.