Fisher & Paykel RX216DT7XV2 Installation Instructions And User Manual page 43

Ice and water
Problem
No indicator lights
are lit on display.
Ice or water are not
dispensed when
pads are pressed.
Possible causes
Freezer door is not closed.
Refrigerator is not plugged
in.
Fuse is blown, or circuit
breaker needs to be reset.
Power outage has occurred. Call local power company listing to report
Refrigerator is in Sabbath
mode (select models).
Freezer door is not closed.
Controls are locked
Water tank is filling.
Ice bin not installed
properly.
Ice maker has just been
installed or a large amount
of ice has been used.
Water pressure is too low.
Water filter is clogged or
needs to be changed.
Troubleshooting
What to do
Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
Plug in refrigerator.
Replace any blown fuses.
Check circuit breakers for any tripped
circuits.
outage.
See Sabbath mode, page 15.
Verify that freezer door is closed. Power is
removed from the control when freezer door
is opened.
See Display and Dispenser Lock, page 23.
At initial use, there is an approximate
1 – 2 minute delay in dispensing while the
internal water tank is filling.
Reinstall ice bin (see page 25).
Wait 24 hours for ice production to begin or
for ice maker to restock after emptied.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
Change water filter (see page 28).
41
EN