Fuse Replacement - 250 Hp Model - Mercury 200 OptiMax Manual

The electrical wiring circuits on the outboard are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate and
correct the cause of the overload. If the cause is not found, the fuse
may blow again.
Open the fuse holder and look at the silver colored band inside the
fuse. If the band is broken, replace the fuse with a new fuse of the
same rating.
d
20
h
a - Good fuse
b - Blown fuse
c - Diagnostic circuit ‑ 2 amp fuse
d - Spare fuse slot
e - SmartCraft data bus circuit ‑ 5 amp fuse
f - Ignition coil circuit ‑ 20 amp fuse
g - Accessories/cowl mounted tilt switch/wake power to ECM
‑ 20 amp fuse
h - Electric fuel pump/ECM driver power/oil pump circuit/
injectors ‑ 20 amp fuse
Fuse Replacement ‑ 250 hp Model
IMPORTANT: Always carry spare 5 and 20 amp fuses.
MAINTENANCE
a
b
g
20
20
f
c
61
d
2 5
e
28750