Lenovo RackSwitch G8264 Installation Manual page 45

1.Locate, record, and retain the product switch information in order to configure and register your
product. See "Recording Important Product Information" on page
2.Remove the rear cover screws:
3.Attach front mounting brackets (Item 1) and rear mounting brackets (Item 6) to each side of the switch
with M4 screws (Item 2). Torque the screws to approximately 2 newton‐meters (Nm) +/‐ 0.1 Nm (17.7
inch‐pounds).
4.From the front, slide the switch into the rack at the desired height.
© Copyright Lenovo 2017
To install the G8264 in an iDataPlex rack, complete the following steps:
Note: If this switch is a replacement switch, copy the product information
from the original switch onto the RID label that is shipped with
replacement switch and affix the new label to the bottom of the new
switch.
32.
1
2
Chapter 3: Installing G8264 Hardware and Options
6
45