1.Remove the power cord from the module's power connector.
2.Press the release latch of the power supply module, and slide the module out of the bay.
Release Latch
© Copyright Lenovo 2017
To remove a hot‐swap power supply module, complete the following steps:
Attention: Do not leave the power-supply bay empty for more than 90 seconds
while the switch is operating. Either replace the power supply module or install a
blank power filler plate.
To return the component to customer service for replacement, see Appendix A,
"Getting Help and Technical Assistance" on page
required information that is necessary to return a component. After you remove the
component, securely pack the component for shipping.
87 to help you gather all the
Chapter 4: Removing and Replacing G8264 Components
59