Hard Ceiling Mount - GeoVision GV-FE2301 User Manual

1.6.1 Hard Ceiling Mount

All Models except GV-FER12203
Without IR LED Ring
Note: To connect wires, cables and the IR LED ring, see 1.7 Connecting the GV-Fisheye
Camera.
1. Place the installation sticker on the ceiling board. The 3 red dots indicate the location of
the screws. To install GV-Fisheye Camera with PoE converter (GV-FE3403 / 5303), drill
the 3 holes and the rectangle block indicated as "PoE Converter"; to install GV-Fisheye
Camera only with the IR LED ring (GV-FE3403 / 5303 and GV-FER3403 / 5303), drill the
3 holes indicated as "Device" and the circle indicated as "IR".
2. At the 3 red dots, drill a hole slightly smaller than the plastic screw anchors provided.
3. Insert the 3 plastic screw anchors in the drilled holes.
Figure 1-7
Introduction
1
With IR LED Ring
21