Checking The Coolant Level - KTM 690 Enduro R EU 2012 Repair Manual

19 WATER PUMP, COOLING SYSTEM
19.4

Checking the coolant level

Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
» If the coolant level does not meet specifications:
–
Correct the coolant level and find out the cause of the loss.
Alternative 1
Alternative 2
–
Mount the radiator cap.
Condition
Engine is cold.
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Check the coolant level in the compensating tank
The coolant level must be within the range shown in the figure.
» If the coolant level does not meet specifications:
–
Correct the coolant level.
Alternative 1
B01293-10
Alternative 2
–
Screw off the radiator cap
The radiator must be completely filled.
» If the coolant level does not meet specifications:
–
Correct the coolant level and find out the cause of the loss.
Alternative 1
Alternative 2
601799-10
–
Mount the radiator cap.
Coolant ( p. 210)
Coolant (mixed ready to use) (
Coolant ( p. 210)
Coolant (mixed ready to use) (
and check the coolant level in the radiator.
2
Coolant ( p. 210)
Coolant (mixed ready to use) (
p. 210)
.
1
p. 210)
p. 210)
168