Wiring Of Contact Output Signal - SMC Networks HRS090-A...-20 Series Original Instructions Manual

3.3.7

Wiring of contact output signal

Be sure to turn OFF the breaker of the facility power supply (the user's
machine power supply) before wiring.
The specifications of the contact for each signal output are shown below.
Contact output
Contact output signal 1
（Terminal no.0,8）
Contact output signal 2
（Terminal no.1,9）
Contact output signal 3
（Terminal no.2,10）
HRS090 Series
Contact output signals are the signals that output the status of this product.
Contact specification of each signal output is shown below
Table 3-11 Signal output contact spec. at the time of shipment
Signal explanation
(Default setting)
Operation status signal
output
Remote status signal
output
Alarm status signal
output
[Tips]
This product has three output signals which can be customized depending on
the customer's application
Signals below can be output. Refer to the Communications Operation Manual
for more details.
・Ready completion (TEMP READY) signal output
・Operation stop alarm signal output
・Operation continuation alarm signal output
・Selected alarm status signal output
・Operation start timer setting status signal output
・Operation stop timer setting status signal output
・Recovery from power failure setting status signal output
・Anti-freezing setting status signal output
・Contact input signal detecting output
・Warming up function setting status output
・Anti-snow coverage function setting status output
Chapter 3
Operation
During operation:
During operation stop:
A
With power supply
During remote operation:
During non-remote
A operation:
With power supply
While alarm being
generated:
While alarm not being
B
generated:
With power supply shut
HRX-OM- T002
Transport and Setting Up
Contact closed
Contact open
Contact open
cutoff:
Contact closed
Contact open
Contact open
cutoff:
Contact open
Contact closed
Contact open
off:
3.3Installation
3-25