Table of Contents
Advertisement
Installation Instructions
S T A R T
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
S T O P
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
R E P E A T O P T I O N
0 - 4
X
R A N D O M I Z E
0 = N O 1 = Y E S
X
10-2
Start Time
01-12 = hour
00-59 = minute
0 = AM; 1 = PM
Days = place "1" under days
[∗] to continue
Stop Time
01-12 = hour
00-59 = minute
0 = AM; 1 = PM
Days = place "1" under days
[∗] to continue
Repeat Option
0 = do not repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly
(every other week)
3 = repeat schedule every third
week
4 = repeat schedule every
fourth week
[∗] to continue
Randomize
0 = no
1 = yes
[∗] to continue
Enter the event's start time and days of the week to occur.
To select days, position the cursor under the desired days using the
[∗] key to move forward, then press "1" to select the day.
Enter the event's stop time and days of the week to occur, if
applicable.
To select days, position the cursor under the desired days using the
[∗] key to move forward, then press "1" to select the day.
This entry applies only to the following events:
1 (relay on/off)
2 (user access)
3 (latch key report)
Enter the desired repeat option for this schedule.
e.g., To make a schedule that happens everyday you would select all
days with a repeat count of 1. To make a schedule that runs for one
week then stops, select everyday with a repeat count of 0.
Applies to events 01 and 11.
If selected, the scheduled start and stop times will vary within 60
minutes of the "hour" time. For example, if a schedule is set to start
at 6:15pm, it will do so the first time 6:15pm arrives, but on
subsequent days it will start anytime between 6:00 and 6:59 p.m.
NOTE: Do not use the random option if the start and stop times are
within the same "hour" setting, otherwise unpredictable results may
occur (e.g., the randomized stop time may occur before the start time).
Advertisement
Table of Contents
