Table of Contents
Advertisement
Installation Instructions
Wireless Key Programming Templates
This procedure programs the wireless keys, but a key is not active for arming/disarming until
it is assigned to a user number (see System Operation section, assigning attributes command).
If the D key was previously pressed (from *58 Menu mode) to program 5804 and/or 5804BD wireless
keys, the following screens appear.
PROMPT
TEMPLATE ?
1–6
1
L
01
02
03 04
T
23
22
21 23
PARTITION
1
ENTER START ZONE
00 = QUIT
36
INPUT S/N
L
AXXX-XXXX
–
XMIT TO CONFIRM
PRESS
TO SKIP
5-6
VALID ENTRIES
Template Number
1–3 = 5804 templates
4–6 = 5804BD templates
[∗] to continue
Template Display
[∗] to continue
Partition
1 = partition 1
2 = partition 2
3 = common partition
[∗] to continue
Start Zone Number
[∗] to continue
Serial Number
[∗] to continue
Confirm
[∗] to continue
EXPLANATION
1. Enter Template number 1–6 (from next page).
See the defaults provided for each template in the chart that
follows these procedures.
2. Select from templates. Press [ ] to display template (1 shown
selected). NOTE: If necessary, press [#] to back up and re-enter
template number.
3. If you want to return to the *58 Menu mode Summary Screen,
press [#].
4. When [ ] is pressed, the selected template will be displayed.
Top line of display represents loop numbers, bottom line
represents zone type assigned for each loop.
5. Press [ ] to accept template.
FA168CPS.
6. Enter the partition in which the key is to be active.
7. Press [∗] to continue.
8. The system will search for the highest available consecutive 4-
zone group (the four zones in the case of the 5804 and 5804BD),
and display the lowest zone number of the group.
If you want to start at a different zone, enter the zone desired,
and press [ ]. If that zone number is displayed, the system has
the required number of consecutive zones available, beginning
with the zone you entered. If not, the system will again display a
suggested zone that can be used.
If the required number of consecutive zones is not available at all,
the system will display "00".
To quit this mode and return to *58 Menu mode, enter 00 at
this prompt.
9. Press [ ] to accept.
10. Manually enter the serial number printed on the label for the
wireless key or press and release the button to transmit its serial
number.
11. Press [ ] to accept the serial number. The system will check for
duplicate.
12. If necessary, press the [#] key to back up without saving, and re-
enter the serial number.
Use the [A] key to move forward within the screen, and the [B] key to
move backward.
13. If "Yes" was entered at the SET TO CONFIRM? prompt
previously (see first prompt following entry into the ∗58 Expert
Programming Mode), the display on the left will appear. Confirm
serial and loop numbers by activating the wireless key.
IMPORTANT:
When confirmed, the key is not active for arming/disarming until it
is assigned to a user number (using the assigning attributes
command, attribute "4"). See System Operation section for
procedure.
Advertisement
Table of Contents
