Using The Adaptec Raid Utility; Installing The Raid Driver During Os Installation - Supero A+ Server 4022G-6F User Manual

Figure 5-7.Adaptec RAID Utility Program Screen

Using the Adaptec RAID Utility

The Adaptec® RAID Utility program is where you can define the drives you want
to include in the RAID array and the mode and type of RAID.

Installing the RAID Driver During OS Installation

You may also use the procedure below to install the RAID driver during the Window's
OS installation:
1. With the Windows OS installation CD in the CD-ROM drive, restart the
system.
2. When you see the prompt, hit the <F6> key to enter Windows setup.
3. Eventually a blue screen will appear with a message that begins "Windows
could not determine the type of one or more storage devices . . ." When you
see the screen, hit the <S> key to "Specify Additional Device", then insert the
driver diskette you just created into the floppy drive.
4. Highlight "Manufuacturer Supplied Hardware Support Disk" and hit the
<Enter> key.
5. Highlight the first "Adaptec RAID" driver shown and press the <Enter> key to
install it.
6. Press <Enter> again to continue with the Windows setup.
Chapter 5: Advanced Serverboard Setup
5-29