Port Side Of The Brocade 6505 - Brocade Communications Systems 6505 Hardware Reference Manual

•
An RJ45 10/100 BaseT Ethernet system management port, in conjunction with
EZSwitchSetup, that supports switch IP address discovery and configuration, eliminating the
need to attach a serial cable to configure the switch IP address and greatly increasing the ease
of use.
•
One RS-232 serial port with RJ45 connector for initial switch setup (if not using EZSwitch
Setup) and factory default restoration. (the integral LEDs remain unlit at all times)
•
A USB 2.0 port that provides storage for firmware updates, output of the supportSave
command and storage for configuration uploads and downloads.
•
One power supply and fan FRU in base model. There are two fans per FRU. Second FRU
available for redundancy and hot-swap capability.
•
Rack-mount design (1U form factor) in a 19-inch EIA rack.
•
One LED (green/amber) per FC port to indicate status.
•
One LED (green) for system power.
•
One LED (green/amber) for system status.
•
Two Ethernet port LEDs (integrated with RJ45) for speed and port activity. Green LED for port
speed and amber LED for port activity.
•
SEEPROM for switch identification.
•
Voltage monitoring.
•
Fan monitoring.
•
Temperature monitoring.
•
Real-time clock (RTC) with battery.

Port side of the Brocade 6505

The port side of the Brocade 6505 includes the system status LED, console port, Ethernet port and
LEDs, USB port, and Fibre Channel ports and the corresponding port status LEDs.
Figure 1
1
5
1
2
3
4
Brocade 6505 Hardware Reference Manual
53-1002449-01
DRAFT: BROCADE CONFIDENTIAL
shows the port side of the Brocade 6505.
2 4
3
6 7 8
System status LED
Management Ethernet port with LEDs
USB port
FC ports 0-3(all LEDs above)
Port side of the Brocade 6505
5 System power LED
6 Serial console port
7 Switch ID pull-out tab
8 FC ports 4-7
1
3