Brocade Communications Systems 6505 Hardware Reference Manual page 41

DRAFT: BROCADE CONFIDENTIAL
Complete the following steps to replace a combined power supply and fan assembly in a Brocade
6505.
DANGER
The power supply switch must be in the off position when inserting it in the chassis. Damage to
the switch could result if a live power supply is installed.
1. Ensure that the new power supply and fan assembly has the same part number as the power
supply and fan assembly being replaced.
2. Orient the new power supply and fan assembly with the captive screw on the right, as shown in
the figure.
CAUTION
Do not force the installation. If the FRU does not slide in easily, ensure that it is correctly oriented
before continuing.
3. Gently push the power supply and fan assembly into the chassis until it is firmly seated.
4. Using the Phillips screwdriver, secure the power supply and fan assembly to the chassis by
tightening in the captive screw.
5. Plug the power cord in to the power supply and fan assembly and power on the unit by pressing
the AC power switch to the I symbol.
6. Verify that the LED on the new power supply and fan assembly displays a steady green light
while the Brocade 6505 is operating. If the LED is not a steady green, ensure that the power
supply is securely installed and seated properly.
7. Optionally, if using the Command Line Interface (CLI), enter the psShow command at the
command line prompt to display the status. Power supply and fan assembly status can also be
viewed using the Web Tools application.
Brocade 6505 Hardware Reference Manual
53-1002449-01
Removing and replacing a power supply and fan assembly
4
29