Programming Memory - Vision TC2-AMP2 Owner's Manual

NOTE 1: The speaker cable must be unshielded with a gauge of no less than 0.75mm.
THE WARRANTY WILL BE VOID IF YOU USE UNSUITABLE SHIELDED CABLE.
NOTE 2: THIS IS A LOW-IMPEDANCE AMPLIFIER. DO NOT ATTEMPT TO CONNECT 100V
LINE SPEAKERS (Normally any speakers with "t" in the part code)
Alternative Configuration
1. Techconnect
2. TC2-AMP2 module
3. UK Single gang Surround
4. Power cable
1

PROGRAMMING MEMORY

The Techconnect Amplifier turns on automatically when mains power turned on.
The amplifier has an adjustable memory:
Mode 1: Assumes a pre-set input and volume
Mode 2: (default) Resumes last input and volume
To view current mode and switch mode:
1. Turn amplifier off
2. Hold down volume+ then power buttons for 5 seconds. Input indicator will flash 8 times
showing current mode.
3. To change mode repeat step 2. Input indicator will flash 8 times showing the other mode.
4. Turn mains power off to apply change to memory.
2
3
4
6
TC2-AMP2_manual_en