Resetting The Breaker Switch; Replacing The Power Cord - Stryker 240-099-156 Instructions For Use Manual

Resetting the Breaker Switch

To reset the breaker switch:
1. Open the rear door of the cart.
2. Locate the breaker switch and reset it.

Replacing the Power Cord

The Connected OR Cart power cord is replaceable.
To replace the power cord:
1. Power the cart off and disconnect the power cord from supply mains.
2. Open the rear door of the cart.
3. Detach the power cord plate by removing the two screws using a 3 mm hex key.
12 EN
Figure 5 – Location of the breaker switch
P44082 Rev. D