Viconics VTR8300 Series Installation Manual page 3

• If replacing an existing VTR8300 Room Controller, label wires before removal of Controller.
• Electronic controls are static sensitive devices. Discharge yourself correctly before manipulating and installing
Controller.
• A short circuit or wrong wiring may permanently damage Room Controller or equipment.
• All VTR8300 series Room Controllers are designed for use as operating controls only and are not safety devices.
Tampering with the devices or unintended application of the devices will result in a void of warranty.
• This transmitter must be installed to provide a separation distance of at least 4in (10cm) from all persons and
must not be collocated or operating in conjunction with any other antenna or transmitter.
LOCATION
• Do not install on outside wall
• Do not install behind a door
• Do not install in areas with direct heat source.
• Do not install near any air discharge grill.
• Do not install in areas exposed to direct sunlight.
• Ensure Room Controller has sufficient natural air circulation
• Ensure wall surface is flat and clean.
• Ensure external thermal sensor wirings are away from noisy electrical sources
• Install 1.3 to 1.5 meter (52 to 60 inches) above the floor
CLEANING THE ROOM CONTROLLER
• Use a soft, pre-moistened lint-free cloth for cleaning.
• Avoid getting moisture in openings.
• Do not spray anything directly on the Room Controller or use compressed air.
• Do not use caustic/corrosive products, ammonia, solvents or any cleaning product containing alcohol or grit.
• Never use tools directly on the touchscreen.
• Never use paint on the Room Controller.
• Do not drop or crush the Room Controller, or allow it to come into contact with liquids.
• Do not use a damaged device (such as one with a cracked screen).
• Performance can be affected if the glass on the screen is broken.
• Failure to comply with these recommendations will result in damage to the unit and void the manufacturer's warranty.
Viconics Technologies Inc.
028-0414-07
www.viconics.com
3
sales@viconics.com
April 2019