Tools Needed For Assembly; Unpacking Instructions - Fanimation Bayhill LB230VZ Owner's Manual

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan

Tools Needed for Assembly

• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 7). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in fi nding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 13)
Hanger
Bracket
Fan Motor
Assembly
NOTE: The illustration shown is not to scale or its
actual confi gurations may vary
• One wire stripper
• Three wire connectors
(supplied)

Unpacking Instructions

Downrod/
Hanger Ball
Assembly
Canopy Screw
Cover
Switch Cup/Adapter
Housing Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Fan Motor assembly
• Motor Coupler Cover
• Housing Switch Cup/
Adapter assembly
• Hanger Bracket with
Shoulder Screws
• Downrod/Hanger Ball
• Ceiling Canopy
• Canopy Screw Cover
assembly
• Blade Holder (4)
• Wood Blades (4)
Ceiling
Canopy
Motor Coupler Cover
Blade Holders
Hardware Bags
3
Materials
Wire Size A.W.G.
14
12
• Hardware bags:
– Nine ¼-20 x 14mm (blade
holder to fan motor hub) screws
3
– Thirteen / -24 x 15mm (blade
16
to blade holder) pan-head
screws, fiber & flat washers
– Four wire connectors
– Ceiling Support Cable
with clamp
– Flat washer
– Lag bolt
– Fanimation screwdriver
C27 Wall Control
Wood Blades