Fanimation Bayhill LB230VZ Owner's Manual page 5

How to Assemble Your Ceiling Fan (cont'd)
3. Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with
the Hairpin Clip. (Figure 2) Be sure to push the straight
leg of the hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip snaps
around the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working loose. Pull
on the Downrod to make sure the clevis pin is properly
installed.
4. While pulling up on the Downrod, securely tighten the
two 3/16-24 x 3/8˝ setscrews in the downrod support.
(Figure 3)
5. Route wires through opening in Motor Coupler Cover
and Canopy. Position Canopy on fan shown with open
side facing up. (Figure 3)
6. Reinstall the Hanger Ball (Figure 1) on the Downrod
as follows. Route the three 80˝ wires and support cable
through the Hanger Ball. Position the Pin through the two
holes in the Downrod and align the Hanger Ball so the Pin
is captured in the groove in the top of the Hanger Ball. Pull
the Hanger Ball up tight against the pin. Securely tighten
the setscrew in the Hanger Ball. A loose setscrew
could create fan wobble.
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
7. The fan comes with blue, black, and white leads. Before
installing fan, measure up approximately 6-9 inches above
top of Downrod/Hanger Ball Assembly. Cut off excess wire
and strip back insulation ½˝ from end of wire.
8. You have now completed the upper assembly of your
new ceiling fan. You can now proceed with the hanging
and the electrical wiring of your fan.
Downrod
Support
Hairpin Clip
Ceiling
Canopy
Canopy
Screw
Cover
Motor
Coupler
Cover
5
Clevis
Pin
Setscrew (2)
Figure 2
Downrod
Pin
Setscrew
Figure 3