How To Wire And Operate Your C27 Wall Control - Fanimation Bayhill LB230VZ Owner's Manual

How to Wire and Operate Your C27 Wall Control

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Installing Wall Control (Figures 1 & 2):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Make wiring connections with wire nuts as shown in
Figure 1.
– One black/white wire from wall control unit to black
wire (hot supply).
– One blue wire from wall control unit to blue wire
(light).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
• Attach wall control unit to outlet box using the two
6-32 screws provided.
• Attach wall plate to the switch control front using the two
small screws provided.
• Restore electrical power.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the wall plate and the wall.
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
2. Operating & Using Wall Control (Figure 3):
NOTE: If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning. Then
slide the reverse switch to the opposite position and turn
fan on again. The reversing switch is located on side of
the switch cup.
Fan Switch
• 4 Slide Switch – low fan speed
• 3 Slide Switch – low-medium fan speed
• 2 Slide Switch – medium fan speed
• 1 Slide Switch – high fan speed
• _ Switch – fan off
Light Switch
• Dimmer Slide Switch – low to bright light
• _ Switch – light off
BLK/WHT
BLUE
TO LIGHT
BLK
TO FAN
7
120 VAC SUPPLY
(User Supplied)
TO HOT
Figure 1
NOTE: Supply wires and fan wires
omitted for clarity.
Figure 2
Figure 3
3 5 ⁄ in.
16