Table 4-9 Register Of Prot Status - Prodigit 3110 Series Operation Manual

[STATe : ] PROTect
Syntax: [ STATe: ] PROTect?{;NL}
Purpose: Query if there have protection flag which had been set in this 3110 series
Description： 1.PROT? means the status of Protection of 3110 series. "1" means OPP
occurred."4"means OVP. "8" means OCP. Table 4-9 shows the
corresponding number of protection status
2.Use command CLR to clear the register of PROT status to be "0"
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
7 6 5

Table 4-9 register of PROT status

[STATe :] CCR {AUTOR2}
Syntax: [STATe : ] CCR {AUTOR2}{;NL}
Purpose : Set the CC MODE RANGE to be forced to switch to RANGE II
Description : It will switch the RANGE position automatically when setting for AUTO Set
R2 when implementing RANGE II
[STATe :] NGEABLE {ONOFF}
Syntax : [STATe: ] NGEABLE {ONOFF} {;NL}
Purpose :To set the GO/NG check function enable or disable.
Description : To set the function of NG judgment opens when POWER ON. When setting
for POWER OFF, the function of NG judgment will not be implemented.
[STATe :] POLAR {POSNEG}
Syntax: [STATe : ] POLAR {POSNEG} {;NL}
Purpose: Set for the display of the voltage meter shows the pole is contrary or not
Description: Set the display of the voltage meter shows the pole. If it shows POS, that
means the pole is not contrary. If the pole is contrary, it will show NEG
[STATe: ] START
Syntax: [STATe : ]START {;NL}
Purpose: Set for Load to implement the test.
Description: Set for Load to implement the test, and according to TEST CONFIG
(TCONFIG), the Load will start to test the items and parameters which are
required
[STATe : ] STOP
Syntax: [STATe : ]STOP {;NL}
Purpose: Set for Load to stop the test
？
4 3 2 1
3110 Series Operation Manual 75
0
Over Power Protection (OPP)
Over Temperature Protection (OTP)
Over Voltage Protection (OVP)
Over Current Protection (OCP)