Table 4-8 Module For Each Series - Prodigit 3110 Series Operation Manual

Purpose: To set the upper/lower limit value of threshold voltage.
Description: This command is to set the upper/lower limit value of threshold voltage.
When input voltage is lower than the lower limit value or higher than the
upper limit value, NG indicating light will come on to indicate "NO GOO".
[LIMit : ] SVHSVL
Syntax : [LIMit: ] {SVHSVL}{SP}{ NR2 }{;NL}
[LIMit: ] { SVHSVL} ?{;NL}
Purpose : To set the upper/lower limit value of short current.
Description: This command is to set the upper/lower limit value of short current. When
short current is lower than the lower limit value or higher than the upper
limit value, NG indicating light will come on to indicate "NO GOOD".
4.6.2. STAGE Set and read the status of Load
[STATe:] LOAD {SP}{ONOFF}
Syntax: [STATe:] LOAD{SP}{ONOFF}{;NL}
[STATe:] LOAD ?{; NL}
Purpose: Set and read the status of Sink Current or not
Description: This command is used for setting the status of Sink Current. When setting it
to ON, the Load is going to sink current from appliance. When setting it to
OFF, the Load would not act.
[STATe : ] MODE {SP}{CCCRCVCP}
Syntax: [STATe : ] MODE {SP}{CCCRCVCP}{;NL}
[STATe : ] MODE ?{ ;NL}
Purpose : Set and read the mode of LOAD
Description : Load is acting under these four modes as the following TABLE 4-8. When
reading the Loading Operation mode, the return value 0│1│2│3 are meant
to be CC│CR│CV│CP
3110 series
[STATe : ] SHORt {SP}{ONOFF}
Syntax : [STATe : ] SHORt {SP}{ONOFF}{;NL}
[STATe : ] SHORt ? {;NL}
Purpose: Set and read the short-circuit test of Load
Description: This command is for setting the Load to make a short-circuit test. While
setting for the ON, the V+, V- pin of Load like short-circuit status.
CC CR
(0) (1)
V V

Table 4-8 module for each series

3110 Series Operation Manual 73
CV CP
(2) (3)
V V