Input Fuse; Fig 2-2 Fuse Receptacle - Prodigit 3110 Series Operation Manual

2-2 Input Fuse

This product is fitted with a mains input fuse. If it needs to be replaced please adhere to the
Following procedure.
BEFORE replacing the fuse you must switch off the unit and mains power outlet and
disconnect the plug of the AC Power cable from the input socket of the 3110 series.
If prior to exchanging the fuse, there is any abnormal noise or odour do not use the unit.
Please inform your local sales office to organise repair of the 3110 series.
To avoid the risk of fire or electronic shock the fuse must only be replaced with same type
and rating as the original. Any replacement fuse used should meet your national safety
standards. Any use of improper fuse or shorting the Fuse holder would be extremely
dangerous and would be strictly prohibited.
2.2.1 Check the rating of the mains input fuse. Replace only with the correct
2.2.2 The AC line fuse is located below the AC line socket (see Fig 2-2). Use
2.2.3 Refit the fuse holder and connect the power cord.
Type and rating.
For 100V/115Vac Input use T1A/250V (5*20mm),
For 200V/230Vac Input useT0.5A/250V (5*20mm)
A small screwdriver to remove the fuse holder. Replace the failed fuse
With the appropriate type and rating according to your mains voltage.
(See Table 1-2)

Fig 2-2 FUSE RECEPTACLE

3110 Series Operation Manual 11
T1A/250V (5*20mm)
T0.5A/250V (5*20mm)