Table of Contents
Advertisement
10 PRODIGIT
Chapter 2 Installation
The 3110 Series was carefully inspected, tested and calibrated before shipment. If damage to
the instrument has occurred during transport, please inform Prodigit's sales and service office or
representative. Your 3110 series was shipped with a power cord for the type of outlet used at
your location. If the appropriated cord was not included, please contact your nearest sales office
to obtain the correct cord. Refer to "check line voltage" to check the line voltage selection and
fuse type.
2-1 Check line voltage
The 3110 Series can be operated from a 100/115 or 200/230Vac input as indicated on the
label on the rear panel. The input is switchable so please make sure that the switch is set
correctly for your nominal mains input before turning on the mains power. The procedure
below details how to change the switch position:
2.1.1
2.1.2
With the 3110 series power OFF, disconnect the power cord.
Refer the drawing on the rear panel in Fig 2-1, set the switches to the
Proper voltage as described in the following:
a. Set Switch to 100V/115V for 115Vac line voltage
b. Set Switch to 200V/230V for 230Vac
Note: 100Vac and 200Vac is used for Japan only (Option)
Fig 2-1 SET OF SWITCH
Advertisement
Table of Contents
