Troubleshooting - Quell QM10 Manual

Troubleshooting:

Problem
Smoke alarm device
does not sound when
tested.
The alarm"chirp"with
red LED flashes on
ceevery 40 seconds.
Smoke alarm device chirp
occurs every 40 seconds
（alarm goes into fault
mode）.
Smoke alarm device
sounds unwanted
alarms intermittently
or when residents are
cooking, taking showers,
etc.
Action
1.Fit the alarm on the bracket and
turn the alarm body clockwise,
until locking in place on the
bracket.
2.Clean smoke alarm device.
Please refer to the
"maintenance and cleaning"
section.
3.If there are still failures during
warranty, you can return to
your retailer.
4.If the unit is out of warranty,
please replace with
another new alarm.
The battery is under low battery
status, please replace the smoke
alarm device.
Clean smoke alarm device.Please
refer to the"maintenance and
cleaning" section. Purchase and
install another smoke alarm
device if the problem still exist.
1. Press test button to pause alarm.
2. Clean smoke alarm device.
Please refer to the
"maintenance and cleaning"
section.
3. Move smoke alarm device to
new location and press test
button.
10
2