Ecom J2KN Operation Manual page 16

5.2 Advanced DAS software using the Data Interface Box
Kit contents:
ECOM Data Interface Box
AC Power Adapter
(2) 20' RJ45 telephone cables
Advanced DAS Software disk
USB cable
Software installation help guide
Please note: Advanced DAS software should be installed on the PC prior to synchronizing the
ECOM Data Interface Box with the analyzer and PC.
Set-up directions:
The Data Interface Box must be synchronized with the corresponding J2K / J2KN for wireless
operation the first time it is used with the analyzer.
Please follow these steps:
1. Switch on the analyzer, and allow it to complete the 3 minute auto-zero.
2. Using one of the cables, connect the J2K base module port to the base module port on
the back of the interface box.
3. Using the other cable, connect the J2K Remote Control port to the remote control port on
the back of the data interface box.
4. Connect the USB cable to the Data Interface Box and to the PC.
5. Connect the AC power adapter to the Data Interface Box and move switch to the ON
position. You should see the RED power light on the front.
6. Boot up the PC and start the Advanced DAS program. You should see real-time values
from the analyzer.
7. Disconnect the telephone cables from the base module, remote control and data interface
box.
8. All future operation of the J2K/J2KN data interface box can be performed without the use
of the telephone cables.