Per-Port Leds; Configuring Power Over Ethernet; Power Over Ethernet Configuration Commands - Extreme Networks Summit 300-48 Software User's Manual

Table 58: Power Supply Mode Commands (continued)
Command
reset inline-power slot <slot number>
If there are an excessive number of power supply failures (five or more within a five minute period), a
critical syslog message is issued and the PoE system shuts down until reset by the operator.
The error message is similar to the following:
CRITICAL: Excessive inline-power PSU failures for slot <slot number> - operator
inline-power reset required

Per-Port LEDs

The per-port LEDs indicate link and power status for PoE usage, as indicated in Table 59:
Table 59: Per-Port LEDs
Non-powered
device
Device powered blinking amber
Power Fault
NOTE
Wait for the LED to extinguish before reconnecting to the port.

Configuring Power Over Ethernet

Use the inline power commands in Table 60 to configure PoE on Summit 300-48 switch ports.
NOTE
Configuration parameters affecting operational parameters require the port or slot to be first disabled.
Table 60: Power Over Ethernet Configuration Commands
Command
enable inline-power
disable inline-power
Summit 300-48 Switch Software User Guide
Description
Use this command to reset the Poe system for a specific slot.
Port Disabled Link Up
off solid green
solid amber
amber/green amber/green
Description
Enables PoE on the switch. Controls whether inline power will be
provided to the system. Default is enable.
Disables PoE on the switch. Setting the value to disable will shutdown
power currently provided on all ports on all slots.
Link Down Activity
off blinking green
amber/green blinking amber
amber/green amber/green

Per-Port LEDs

139