Force Disassociation; Wireless Interface Configuration Commands; Force Disassociation Command - Extreme Networks Summit 300-48 Software User's Manual

Wireless Networking
interface from one profile to another without having to shut it down. Table 41 lists the configuration
commands for wireless ports.
Table 41: Wireless interface Configuration Commands
Command
config wireless ports <portlist> interface [1 | 2] rf-profile
<name>
config wireless ports <portlist> interface [1 | 2]
security-profile <name>
config wireless ports <portlist> interface [1 | 2] channel
config wireless ports <portlist> interface [1 | 2]
power-level
config wireless ports <portlist> interface [1 | 2]
transmit-rate
enable wireless ports <portlist> interface [1 | 2]
disable wireless ports <portlist> interface [1 | 2]
reset wireless ports <portlist> interface [1 | 2]

Force Disassociation

Force disassociation permits client user disassociation based on a recurring schedule, a date and time, or
a particular MAC address. You can also disassociate a user immediately. You can specify access based
on a preferred time periods, such as during off-hours, weekends, and holidays. You can also set up a
user policy on a RADIUS server to allow user authentication based on time of day. To configure force
disassociation, use the command listed in Table 42.
Table 42: Force Disassociation Command
Command
configure wireless ports <portlist>
force-disassociation [all-clients
[every <hour <0-23>> <minute <0-59>>
| time <month <1-12>> <day> <year <yyyy>> <hour
<0-23>> <minute <0-59>>]
| cancel-scheduler
| <mac-address>]
90
Description
Attaches the port in the port list to the named RF
profile. All ports in the port list must have the same
wireless port version.
Attaches the ports in the port list to the named
security profile. All ports in the port list must have
the same wireless port version.
Configures a channel for the specified interface.
Default is Auto for both interfaces.
Configures the power level for the specified
interface (full, half, min, one-eighth, quarter).
Default is full.
Configures a transmission rate for the specified
port. Choice of rates depends upon the mode of the
interface (A or G). Default is 54Mbps.
Enables or disables the specified port interface.
Enables or disables the specified port interface.
Forces the wireless interface to reset.
Description
Configures the client force-disassociation capability. All the
times used as parameters in this command refer to
absolute, not relative times.
• all clients specifies all clients associated with the
port list.
• every specifies a repeating disassociation.
• time parameter specifies a single disassociation at a
specific time on a specific date. If you do not specify the
every or time parameters, the user is immediately
disassociated.
• cancel-scheduler parameter disables forced
disassociation.
• mac-address indicates the MAC address of the client
network interface card.
Summit 300-48 Switch Software User Guide