Summit 400-48T Optional Features; Installing Optional Features; Installing The Summit Xen Card - Extreme Networks Summit 200-24 Hardware Installation Manual

8

Summit 400-48t Optional Features

This chapter describes how to install optional features on "e" series switches..
• Installing Optional Features on page 89

Installing Optional Features

Extreme Networks offers two hardware products that extend the capabilities of the Summit 400-48t. The
Summit XEN Card is an additional card that adds one or two 10 Gigabit uplink modules through the
back of the Summit 400-48t. The Extreme External Power System (EPS) allows you to add a redundant
power supply to the Summit 400 switch to protect against a power supply failure. Both of these
products are additional offerings and available from your sales representative.
Before installing any optional features, be sure to check the Installation Notes provided with the feature
to determine the latest installation process or limitations.

Installing the Summit XEN Card

The Summit 400-48t allows you to add up to two 10 Gigabit uplink modules to increase the bandwidth
of the switch. The Summit XEN Card supports either of these Extreme XENPAK optical transceivers:
• SR XENPAK for the 850 nm range
• LR XENPAK for the 1310 nm range
• ER XENPAK for the 1550 nm range
CAUTION
The Summit XEN Card cannot be hot-swapped. Before installing the Summit XEN Card into the Summit
400-48t, you must turn off the switch. Use only XENPAK modules approved by Extreme Networks.
To install the Summit XEN Card:
1 Disconnect the AC power from the Summit 400.
2 Use a standard screwdriver to remove the blank plate to expose the opening for the card.
3 Install the XENPAK optical transceiver modules onto the card. For more detail on this step, see
"Installing XENPAK Optical Transceiver Modules".
Consolidated "e" Series Hardware Installation Guide 89