Connecting The Eps-Ld Unit - Extreme Networks Summit 200-24 Hardware Installation Manual

1 Place the EPS-LD unit upright on a hard flat surface, with the side you want to face to the front of
the switch toward you.
2 Remove the mounting bracket kit (including screws) from the packaging.
3 Locate a mounting bracket over the mounting holes on one side of the unit.
4 Insert the screws, as shown in Figure 21, and fully tighten the screws with a #1 Phillips screwdriver.
Figure 21: Fitting the mounting bracket
5 Repeat steps 2 through 4 for the other side of the EPS-LD unit.
6 Insert the EPS-LD unit into a 19-inch rack.
NOTE
Mount the EPS-LD so that the output connectors are on the same side as the external connector on
the connecting switch. If you mount the EPS-LD with the connectors facing in the opposite direction
as the Extreme switch connector, leave at least 1 U between the switch and the EPS-LD through
which to slide the cables. Do not route the cables around the equipment rack.
7 Insert the screws into the rack and the mounting bracket on both sides of the unit and fully tighten
with a suitable screwdriver.

Connecting the EPS-LD unit

CAUTION
Do not attach the AC power cord to the EPS-LD unit until the unit is properly grounded at the electrical
outlet and the redundant power supply cable is connected.
1 Connect the keyed end of the EPS-LD cable to the power supply unit(s). The key is a plastic tab on
the cable connector housing that fits into the EPS-LD unit to ensure correct alignment of the
connector.
See Figure 22 for details on the connector key, and see Figure 23 to locate the connectors on the
EPS-LD unit and on the switch.
NOTE
The cable length is 1 meter.
2 Connect the other end of the power supply cable to the Extreme switch.
The connector fits the slot in only one direction.
Consolidated "e" Series Hardware Installation Guide
External Power Supply (45019)
Collin's
ES4K026
XM_054
77