Rack-Mounting The Eps-Ld Unit - Extreme Networks Summit 200-24 Hardware Installation Manual

Summit 300 Optional Features
Table 14 lists the electrical specifications for each EPS-LD unit.
Table 14: EPS-LD power supply specifications
Ratings
Nominal Operating Voltage
Input Voltage Range
AC Line Frequency
Maximum Input Current Rating 10A at 115 VAC, 5A at 230 VAC
Maximum Inrush Current
Output
EPS-LD Input Connector
Maximum continuous DC output shall not exceed 465 Watts.
Table 15 lists the environmental specifications for each EPS-LD unit.
Table 15: EPS-LD operational environmental specification overview
Ratings
Ambient Operating Temperature
Storage and Transportation Temperature
Operating Relative Humidity
Shock—Operational

Rack-mounting the EPS-LD unit

NOTE
When installing an EPS-LD in a rack, make sure air vents are not restricted. Allow for elevated ambient
operating temperatures when installed adjacent to other equipment. Be sure you mount the equipment
within the rack so that the load is evenly distributed.
The EPS-LD unit can be mounted in a rack, or placed free-standing on a tabletop. You can mount the
EPS-LD facing either the front or the back of the rack. For this reason, each unit has two sets of
mounting holes; two on each end. Mounting the EPS-LD so that the unit's output connectors are on the
same side as the external connector on the connecting switch.
CAUTION
Do not use the rack-mount kits to suspend the EPS-LD from under a table or desk, or to attach the
switch to a wall.
To install the EPS-LD, you need the following tools and materials:
• Electrostatic strap
• A #1 Phillips screwdriver
To rack mount each EPS-LD unit:
76
115 VAC or 230 VAC
100 VAC to 240 VAC
50 Hz to 60 Hz
30A at 115 VAC, 60A at 230 VAC
-50 VDC, 7.5 A max, 375 Watts; 12 VDC, 7.5 A max, 90 Watts
IEC320-C14
0 C to +40 C
-40 C to +70 C
10 - 95% RH noncondensing
30 m/s2 (3g)
Consolidated "e" Series Hardware Installation Guide